
AA83-001 InterMUSIC™ Stereo Intercom System
SM09-2A Installation and Operation Manual
April 18, 2012 Rev: 5.00 Page 2-1
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Section 2.0 Installation
2.1 Introduction
Information in this section consists of unpacking and inspection procedures, installation procedures, post-
installation checks, and installation drawings for the AA83-001 InterMUSIC
™
Stereo Intercom, serial
numbers 2939 and later.
2.2 Unpacking and Inspection
Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each unit should have the following:
- AA83-001 InterMUSIC
™
Stereo Intercom
- Installation kit (see section 2.5)
- Product Information Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately to your supplier.
2.2.1 Warranty
All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website
www.aem-corp.com/warranty for complete details.
2.3 Installation Procedures
2.3.1 Warnings
High volume settings can cause hearing damage.
Set the headset volume control to the minimum volume setting prior to
conducting audio tests, and slowly increase the headset volume to a
comfortable listening level.
2.3.2 Cautions
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any logic, audio, or DC
power lines from this unit with 400 Hz synchro wiring or AC power lines. Do not position this unit next to
any device with a strong alternating magnetic field such as an inverter, motor or blower, or significant
audio interference will result.
In all installations, use shielded cable exactly as shown and ground as indicated. Significant problems
may result from not following these guidelines.
Komentáře k této Příručce